Detail Dwyer Fittings/Filters/Mufflers
A wide variety of fittings use with most Dwyer products. Special line filters for the Magnehellic ® Gage and Capsuhelic® Gage allow use with dusty environments. Particulate filters are used for Dwyer Flowmeters to keep the air clean.
The Muffler Accessory can be easily installed to any diaphragm valve with an exhaust. Pneumatic exhaust ports are on the diapragm valves that have dual diapragms and the units with the integral mounted solenoid. The muffler decreases the amaunt of noise when the air is exhausted from the valve. Valves with dual diapragms and an integral solenoid have two exhaust ports and will require one A-237 and one A-238.
Brass test port plug with 1/4″ NPT process connection.
Brass test port plug with 1/2″ NPT process connection.
SS test port plug with 1/4″ NPT process connection.
SS test port plug with 1/2″ NPT process connection.
Brass adapter with 1/4″ female NPT for use with 1/4″ male NPT gage.
Elbow compression fitting, brass 1/8″ NPT to 1/4″ metal tubing.
Compression fitting, brass 1/8″ NPT to 1/4″ metal tubing.
Compression fitting, brass 1/8″ NPT to 3/8″ tubing.
5/16″ nylon tube union.
1/4″ nylon tube union.
1/8″ NPT close coupled street ell, brass.
1/8″ pipe plug, socket hex, plated steel.
1/8″ NPT filter vent plug, nylon and sintered metal.
Brass adapter, 1/8″ female NPT to 1/4″ male NPT.
Bushing, brass, 1/8″ to 1/2″ NPT.
Close nipple, brass, 1/8″ NPT.
90° street ell, brass, 1/8″ NPT.
Coupling, brass, 1/8″ NPT.
Servel adapter, brass 3/8″ and 5/16″ N.F., threads for gas appliances to 1/8″ and 3/16″ ID rubber or plastic tubing.
Adapter, brass, 1/8″ NPT to 3/16″ rubber and 1/8″ ID plastic tubing.
Adapter, nylon, 1/8″ NPT to 3/16″ ID rubber or 1/4″ plastic tubing.
“T” assembly, plastic, for 3/16″ ID rubber or 1/4″ plastic tubing.
“T” assembly, plastic, for 3/16″ plastic tubing.
“T” assembly, plastic, for 1/8″ ID plastic tubing.
Terminal tube, brass, 1/4″ diameter tube, 8″ length.
Flange for mounting A-301, A-302, A-307, A-308 or 1/8″ dia Pitot tubes with compression fitting when interior of duct is not accessible. Aluminum material. With gasket and sheet metal screws.
“T” compression fitting, brass, 1/4″ metal tubing.
Reducer, brass, 1/4″ female NPT to 1/8″ male NPT.
1/2″ plastic hole plugs, 20/bag.
5/16″ metal hole plugs, 20/bag.
Probe extension adapter for Series 640 air velocity transmitter, brass, 1/2″ female NPT x 5/16″ compression.