Detail Elcometer 308 Digital Hygrometer
Digital Hygrometer | Elcometer 308
Before painting it is necessary to check that the climatic conditions are suitable for the coating being applied. These are clearly specified on the paint manufacturer’s product data sheet.
Surface temperature (Ts) and Relative Humidity (%RH) are two key climatic values which are specified on many data sheets.
- Relative Humidity (RH): This is the amount of water vapour taken up by air. Expressed as a percentage, RH is dependent on the air temperature. Typical maximum RH values specified by paint manufacturers are between 75% and 85%.
The Elcometer 308 digital hygrometer has been specifically designed for use in very hot climates where the surface temperature of the substrate can exceed the paint manufacturer’s recommended limits for successful painting Surface Temperature (Ts)
Painting outside recommended limits can have a detrimental affect on the performance and lifetime of the coating. The Elcometer 308 Hygrometer provides a simple and fast measurement of these two critical parameters.
Rugged design: Suitable for use in extreme environments the Elcometer 308 Hygrometer is dustproof and waterproof with fully sealed sensors.
Measurement Hold / Release function: With a single button press readings are ‘held’ on the screen. These can then be recorded before simply pressing the button again to ‘release’ the screen and continue to take further readings as necessary.
Backlight: Bright screen making information easy to read – ideal in dark or confined spaces.
For more information on Hygrometers, read our Hygrometer information page.
Technical Specifications – Elcometer 308 Hygrometer
-4 to +176°F (-20 to +80°C), 0 to 100% RH
0.1°F (0.1°C) / 0.1%
2 x AA 1.5V Batteries or via USB Cable
Greater than 40 hours (Backlight off)
7 x 3 x 1.4″ (180 x 75 x 35mm)
Certificate of Calibration: issued for Fixed Calibration equipment and shows readings and traceability
- Elcometer 308 Hygrometer
- wrist strap
- 2 x AA batteries
- protective pouch with belt clip
- RH & surface probe calibration certificate
- operating instructions